RC10Talk - The Net's Largest Vintage R/C Community

HA HA HA
I love a good joke

yeah... this guy is usually not very funny. But he delivered tonight so I appreciate him right now!

most people I have spoken to are not thrilled with his attitude most of the time.

tranny is back together and man... it is night and day! It is so quiet and runs great!

Thank you so much everyone! Now i need to figure out gearing and motor setup.

I want it fast, but I also want it to launch.

Busted the black piece on the steering servo and the LHS does't have it. Where might I find that?

campbuds wrote:Busted the black piece on the steering servo and the LHS does't have it. Where might I find that?

Are you talking about the Steering linkage itself? or the Servo horn?

You can use most servo horns out there: http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXBME9&P=7 Just cut off the ends you don't need.

If your talking about the servo saver/steering assembly then you'll have to check Ebay,
Or you can get the Stock RC10GT/T2 Steering. It will work on the RC10. http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LX3358&P=M

Your also going to need:
Servo saver Tube Part#9156b
Nose plate screws Part#7306
Servo saver spring Part#9157 (I don't know if they still make it???)
Drag Link Part#6265
And two 4-40 nylon locknuts Part#6222

Check your LHS. I know they made a complete kit and it only cost $11.99. I can't remember the part# right now.

The horn. My LHS had a pack but none fit

oh... never thought of just cutting off the sides I don't need... DUH! I have some like that. Thanks for the great idea!