Page 1 of 1
B3 axle help needed.
Posted: Wed Jun 17, 2009 11:06 am
by rctenracer
I just converted a b3 over to mip cvd's for a b2. The axles just engage the outdrive . Do i use down stops on the shocks to correct or am i just wasting my time. My b3 had 1/4" axles and just what to update to 3/16". The reason i did this because i cant find any b3 1/4" rims . I would like to sell the car but only if is correct.
Re: B3 axle help needed.
Posted: Wed Jun 17, 2009 11:40 am
by Daddeo
The CVD's for a B2 will be shorter by a little bit but you might be able to shim them out. It would be better if you could source a set of CVD's for the B3 specifically.
Re: B3 axle help needed.
Posted: Wed Jun 17, 2009 2:03 pm
by Charlie don't surf
the outer axel half is spaced differently on the b3 the shoulder to pin is different