RC10Talk - The Net's Largest Vintage R/C Community

I've got one more Losi build left, XXT CR Graphite Plus and two to install some missing parts (XX4 WE and my all blue XX CR), the I WILL BE DONE with my Losi builds. This is my XXT CR. As usual my body and decals are in another box. I still need a new set of rear wheels for this one, the ones installed are very good condition used wheels.

Very nice, I didn't know you actually built things , Do you have new rear diveshafts for that truck?, if not I have some that you could have

Reggie

No, I build things..... just Losi products, ask Jason.

My reference guide has what you see pictured listed, PN: A-3090 Dog Bone/D-shaft w/Yoke

very nice xxt, cant say ive seen a red motor plate, is that a personal touch jay?

mrlexan wrote:No, I build things..... just Losi products, ask Jason.

i believe the correct answer should've been.......

mrlexan wrote:No, I build things..... just not rc10's, ask Jason.

No, the red plates were available over the counter from Losi, I believe..... either that or they were offered in red from an aftermarket company. I have never seen one with a header card, but I seem to remember reading a post from Rich Trujillo (did I spell that right) saying they did a few options.

The red one is all I had left. I haven't had any black ones in a while that are new in the package. I kinda like it red.

where do you get all the parts for these cars, it just astonishing!, must have been buying up old hobby stores for years and years.

mrlexan wrote:No, I build things..... just Losi products, ask Jason.

My reference guide has what you see pictured listed, PN: A-3090 Dog Bone/D-shaft w/Yoke

In the pic the right driveshaft looked like it had rotational scratches,( must just be surface rust) I have some that someone was nice enough to give me, thought I might pass them on if needed

There might be a set of aluminum ones floating around somewhere too