whats wrong with this pic and can it be fixed
Posted: Fri Sep 18, 2009 12:40 pm
i got these to put on my rc10 . sometimes ya gota laugh
i got these to put on my rc10 . sometimes ya gota laugh
RC10Talk - The Net's Largest Vintage R/C Community
whats wrong with this pic and can it be fixed
Page 1 of 1
i got these to put on my rc10 . sometimes ya gota laugh
Re: whats wrong with this pic and can it be fixed
Posted: Fri Sep 18, 2009 1:08 pm
? I'm not seeing the issue.
Re: whats wrong with this pic and can it be fixed
Posted: Fri Sep 18, 2009 1:14 pm
look at the ends
Re: whats wrong with this pic and can it be fixed
Posted: Fri Sep 18, 2009 1:20 pm
It is hard to see through the plastic but is the one side not threaded? If so you can use a tap and die set and thread the end.
Re: whats wrong with this pic and can it be fixed
Posted: Fri Sep 18, 2009 1:47 pm
yeah you can thread it. just take your time. i have a bunch of asssociated screws like that. quality control was caught sleeping again.
Re: whats wrong with this pic and can it be fixed
Posted: Sat Sep 19, 2009 2:16 am
I don't see any grooves for the E clip either.
Re: whats wrong with this pic and can it be fixed
Posted: Sat Sep 19, 2009 2:26 am
No grooves for e-clips needed on those. They are the inline stubs so the pin holds them in.