RC10Talk - The Net's Largest Vintage R/C Community

now i have nowhere near the patience that m vice has to do tedious custom hand fabrication. i was bored tonight, so i started cutting some aluminum, and this is what i came up with. i'm not done with it yet, but you get the idea.

props to the twister motor laying on my bench that helped create the bend.

nice dude. how about a pic or two of the rest of the car? looks interesting.

it's my team car. it just has a pr. of tq tires and wide trinity wheels on the back now. i was checking the wheel fitment with one of the pairs of yokomo adapters i have. other than that, it's the same way it was when i took this pic.

Coooool.

I need one of those for my graphite!

sometimes boredom can have good results.

Nice work Jason I just finshes 3 ds nose plates next ill try a few buggy nose plates