RC10Talk - The Net's Largest Vintage R/C Community

I'm looking for a similar body to the one in the picture. It's for a tractor puller project. Is there anything out there that resembles it? The Bolink Legends Sedan is close but I think it's way too narrow. Something 1/10th scale.

Scroll all the way to the bottom.

http://www.mcallisterracing.com/racing/page7.html

Pretty close. Perhaps a bit too rounded around the roof area but there may be nothing else. Thanks.

http://www.bolink.com/carbodies.html

http://www.bolink.com/legendbodies.html

One of these might get you closer.

I know it's not a van but it sure looks good and has the moter area for your twin hemi's

i remember seeing an exact body like that. i can't remember if it was bolink or parma that had it.

The red one above is from parma. Bolink has a sedan also but there's no provision for the open moter section: you'd have to make you're own inner wall