RC10Talk - The Net's Largest Vintage R/C Community

I have a nib Composite craft worlds chassis and would like to build and complete it. I have found some photos and other info on here, but still have qhestions. I know that a rc10t or gt front bulkhead will be needed. What arms do i use and do they have to be rpm's? Also, can a stock rear bulkhead be used? Basically i'm looking for a list of parts needed to complete this as far as suspension parts. Thanks

if you don't have rpm worlds arms, your only other option would be the dynotech klein replacement arms (part #2700/2701). as for the rear bulkhead, a stock one should be fine. you may have to notch the side of the battery box area for clearance for the a-arms. you'll probably want to look for the worlds rear hub carriers, or the rpm rc10gt rear hubs will work. on the front, yes, you'll need a 10t/gt front bulkhead, rpm worlds or dynotech arms, and you can use the stock associated castor blocks and steering knuckles/axles.

don't forget the worlds rear arm mounts, too.

Great, Thanks. I also notice that my chassis has a small notch by where the steering servo would mount. Why is it there, I don't notice it on others i've seen.

that's for servo saver clearance. i don't remember ever seeing a "worlds" chassis that didn't have that cut out.

...... other than that one in the ebay section.

I was checking out the post in the ebay talk section and noticed it, but maybe it's not a worlds chassis

no, it's a worlds chassis. it could just be an early version..... or something like that.