Page 1 of 1
Rc10 kranzel modified oval
Posted: Thu Jan 14, 2010 6:42 pm
by reign79
Well as if i dont have enough builds i got bored waiting on some stuff so i got started on another
Just finished sanding and repainting the chassis and got the front end together not sure what direction this one is going any suggestions?
Re: Rc10 kranzel modified oval
Posted: Thu Jan 14, 2010 6:47 pm
by aconsola
reign79 wrote: not sure what direction this one is going any suggestions?
Left?
Re: Rc10 kranzel modified oval
Posted: Thu Jan 14, 2010 6:49 pm
by reign79
Thanks Anthony isn't that what all dem dare good old boy's do?
Re: Rc10 kranzel modified oval
Posted: Thu Jan 14, 2010 7:17 pm
by aconsola
I think a white rear bulkhead, arms to match the fronts, and an aluminum trackmaster or team pit stop trans would pull it all together.
Re: Rc10 kranzel modified oval
Posted: Thu Jan 14, 2010 7:20 pm
by transamman908
Did Kranzel make a aluminum front bulkhead for those arms?
Re: Rc10 kranzel modified oval
Posted: Thu Jan 14, 2010 8:41 pm
by Charlie don't surf
Yes they did- You need a set of the Kranzel's rear lowering kit for her too- If you want to do it how they ran em in PA you will go with a mid motor configuration as well. And need a set of CW foams
with the rims in white nylon, and a uni carbon rear body mount RPS bellcranks were also the norm. (just looked after posting and saw you have em). Tecnacraft rods were common as well. And that is and original R&D Terminator, all the kits from when Kranzel's bought the rights were in 3k carbon fiber. Looks like a fun project! If you have trouble finding anything LMK I'm sure I have a few bits laying around.
Reggie
Re: Rc10 kranzel modified oval
Posted: Thu Jan 14, 2010 8:48 pm
by scr8p
if you want to get REAL nostalgic with it, you could alter a pair of kyosho optima arms for the front. that's what they ran on the front before they designed their own arms.
i have some already hacked up in the basement.
Re: Rc10 kranzel modified oval
Posted: Fri Jan 15, 2010 12:08 am
by PBR Allstar
transamman908 wrote:Did Kranzel make a aluminum front bulkhead for those arms?
Kranzels still makes the aluminum front bulkhead. An aluminum R&D rear bulkhead though, those are like hens teeth
I have the rear alloy 0*/0* aluminum rear arm mounts too!
Re: Rc10 kranzel modified oval
Posted: Fri Jan 15, 2010 12:16 am
by scr8p
did you buy that bulkhead from me? i had one, but don't remember who i sold it to.
Re: Rc10 kranzel modified oval
Posted: Fri Jan 15, 2010 12:26 am
by Charlie don't surf
Moose racing made a nice rear Terminator bulkhead as well
Re: Rc10 kranzel modified oval
Posted: Fri Jan 15, 2010 10:42 am
by Brat
The alloys are nicely made. Good parts!
Re: Rc10 kranzel modified oval
Posted: Fri Jan 15, 2010 1:56 pm
by PBR Allstar
scr8p wrote:did you buy that bulkhead from me? i had one, but don't remember who i sold it to.
No, that one was off my R&D that I had years ago.