Bearrickster's Associated Rides

Post by **scottmac74** » Tue Feb 23, 2010 8:19 pm

I like it too. I noticed it only because I have always thought of doing the same thing to my 12lw's, I removed the "flash" on the inside (by the motor's endbell) left over from the molding process but I have never had the stones to mill it out, (even though it seems/looks like such an obvious modification). Nice car.

Post by **bearrickster** » Tue Feb 23, 2010 8:47 pm

thank you I like it a lot to. I will be cutting out the ones on my other 12L's also I am getting things ready to paint as soon as my decals arrive.

Post by **GJW** » Wed Feb 24, 2010 12:14 am

good to see your back into your old 1/12th rick. looking unreal, i ran my old 12i a few weeks ago didnt go to bad at all.

love the bodies

Post by **bearrickster** » Sat Feb 27, 2010 6:25 am

thanks wait till the end of next week I will be building a special rc12L ??

Post by **RedScampi** » Sat Feb 27, 2010 12:33 pm

bearrickster wrote:well I bought the lot in the buy section

I wondered if you were going to grab that lot. I should have known!

Post by **bearrickster** » Sat Feb 27, 2010 3:13 pm

RedScampi wrote:I wondered if you were going to grab that lot. I should have known!

Its your fault

I was just looking for some parts to finish the car I got from you. and found it to be way to nice to use for parts, so I fix it to. It is a sickness.

Post by **bearrickster** » Wed Mar 03, 2010 2:56 am

So what servo do you run on a 1/12? I use a Futaba Radio.

Post by **bearrickster** » Wed Mar 03, 2010 3:16 am

the twin's,
I just installed a NIP Dynamic Strut suspension kit on my composite carft runner.
and a CC 12LS conversion kit almost done just waiting on the mail man to finish her up. everything but the motor plate is NIP.

Post by **bearrickster** » Wed Mar 03, 2010 6:18 am

RC12I with mrLexan body mounted. I found a NIP front cross brace, and picked up all of the rear pod parts from Bill, Thank you sir. no I dont know what to do with it? I am real happy with my other two runners. I dought I will run this one.

Post by **markt311** » Wed Mar 03, 2010 7:27 am

bearrickster wrote:I have never had so much fun comeing in last but as you can see the car was assembled incorrectly so it was draging the ground the whole time. we discovered this just before the Main and Mark hooked me up with some taller front tires so it ran much better. but still not corectly. I wanted some last pick before I rip it apart and fix it right. I am thinking of dyeing the red parts black I am not fond of red, what does everyone think?

Wow, no wonder your 12th was such a handfull on the track! I didn't realise the whole chassis was dragging. And I have a funny feeling Rick will be running a DS next year

I really like the all black look

Post by **bearrickster** » Thu Mar 04, 2010 4:51 am

Well I put some paint on my CC RC12L Graphite
this is a MrLexan 1/12 Kremer Porsche 935-K3 this is a great body, I do not recommend metallic paints. the wings on the fenders and back are real hard to get paint into the deep crevasse.

thank you Brandon G I used the pinstripes and no bleeding, and Yes the thin black stripe is painted on.