i.d. on chassis and front end
Posted: Wed Feb 10, 2010 5:27 pm
what bolink chassis and front is this?
RC10Talk - The Net's Largest Vintage R/C Community
i.d. on chassis and front end
Page 1 of 1
Re: i.d. on chassis and front end
Posted: Wed Feb 10, 2010 5:59 pm
that is an advanced racing technology agitator front end and chassis.
Re: i.d. on chassis and front end
Posted: Wed Feb 10, 2010 6:03 pm
wait, the chassis isn't an agitator. i think that is a bolink eliminator.
Re: i.d. on chassis and front end
Posted: Wed Feb 10, 2010 6:06 pm
but it must take a bolink rear pod 
all the rear holes are same as my eliminator chassis and the front end is 1/2" to 3/4" wider than my 10L 
the front mounting holes are different than my eliminator chassis
all the rear holes are same as my eliminator chassis and the front end is 1/2" to 3/4" wider than my 10L the front mounting holes are different than my eliminator chassis
Re: i.d. on chassis and front end
Posted: Wed Feb 10, 2010 6:08 pm
but that agitator front end fits on it right?
Re: i.d. on chassis and front end
Posted: Wed Feb 10, 2010 7:16 pm
yes it will bolt right on. i'm not going to use the front on it because i think it will be to wide. i found out what bolink chassis my trinity front end http://www.rc10talk.com/viewtopic.php?f=38&t=14153 fits on 