Page 1 of 1
Havoc Low Profile Heatsink?
Posted: Sun Feb 14, 2010 1:08 pm
by soniccj5
Does anyone know if the low profile heat sink for the Havoc 1s and 2s will fit the Havoc speed controller included with the Havoc 10.5 Spec combination?
Thanks,
Ed
Re: Havoc Low Profile Heatsink?
Posted: Sun Feb 14, 2010 1:15 pm
by markt311
It will fit, I've never taken the heatsink off my Havoc so I don't know if there's any special tricks to doing it though.
Re: Havoc Low Profile Heatsink?
Posted: Tue Feb 23, 2010 11:52 am
by soniccj5
Installed the heatsink on Monday without any issues.
My body fits without having to move the speed controller. The stock heat sink already scratched off some paint
ED
Re: Havoc Low Profile Heatsink?
Posted: Wed Feb 24, 2010 1:00 am
by Mikeyboy
Any problems with overheating?
Re: Havoc Low Profile Heatsink?
Posted: Wed Feb 24, 2010 6:01 am
by soniccj5
I have not been able to try it yet. I hope to give it a run in the next couple weeks.
Re: Havoc Low Profile Heatsink?
Posted: Wed Feb 24, 2010 8:21 pm
by Mikeyboy
Who sells those? Direct from Novak?
Re: Havoc Low Profile Heatsink?
Posted: Thu Feb 25, 2010 7:24 am
by soniccj5
Re: Havoc Low Profile Heatsink?
Posted: Mon Apr 05, 2010 6:03 pm
by soniccj5
Update: Drove for a full battery(15 mins) without any overheating issues.
ED
Re: Havoc Low Profile Heatsink?
Posted: Tue Apr 13, 2010 5:52 pm
by Lee_123
I had the low profile on 1/12th scale but couldn't get a good wiring run and the plug to the receiver sat so high that it had to be in the center of the car. Because of this and the beer can size capacitors I took the whole thing off and put it on my RC10L. No problems overheating with a 13.5.