RC10Talk - The Net's Largest Vintage R/C Community

After waiting just over a week for new idler gears and CV shafts, I found that I'm missing the bent e-clip that holds on the idler gear pivot to the metal plate in the 6 gear tranny. Anyone know where I can get one? Or atleast something that will work.

Also, will these fit the stock CE rear wheels?

That clip, tires, shock rebuild kit (along with some oil), and a paint job are all I need to finish my CE.

Thanks.

If you pm me your address I will send you an idler pivot bowed e-clip and washer, AE part # 6635.

a01butal wrote:If you pm me your address I will send you an idler pivot bowed e-clip and washer, AE part # 6635.

Thank You. PM sent.

You should be able to find that e-clip at any good hardware store. Just bring in the old one if possible and match it uo.

fastang wrote:You should be able to find that e-clip at any good hardware store. Just bring in the old one if possible and match it uo.

Problem is I don't have the old one. The manual just calls it "large curved "E" clip".

I only read the important parts of the post

Sorry about that!

a01butal wrote:If you pm me your address I will send you an idler pivot bowed e-clip and washer, AE part # 6635.

Got the parts, put it all together and was able to run it. Thank You.
Now I just need to buy dome tires that fit. The losi ones I bought don't quite work.

If there is a slight gap between tires bead and the rim use rubber bands around the rim it grips at both surfaces and keeps from glue them in place.DON