RC10Talk - The Net's Largest Vintage R/C Community

i have raced a graphite team car with some success. i would really like to mount b4 wheels though because i have a lot of them. please help, whatever it takes..Thanks!!

lowery answered his same question yesterday.................

http://www.rc10talk.com/viewtopic.php?f=38&t=15738

might as well link this one, too.......

http://www.rc10talk.com/viewtopic.php?f=38&t=10403

thx guys. i couln't find the previous thread so i thought i'd try again

looks like i need to get dynatech arms to run b4 wheels. this must be how you guys are doing it

yes. the dynotech arms will be needed. this is to help correct the offset of the b4 wheels so the overall width of your buggy stays the same.

you don't have to use the dynotech arms. you can use b4 rear hubs and b44 rear cvds on the stock rear arms. supposedly that works, too.

i got a call into dynatech i think. i could not find rc10 arms on the website. i would like to use the b4 fronts also so i prob should use rears too. thx guys, tired of running my rc10 graphite "only" when i think my holeshots on b3 wheels will work.

They are not labelled as RC10 arms

Klein Rear Replacement A-Arm
http://dynotech-racing.com/partDetail.php?RefNum=2700

Klein Front Replacement A-Arm
http://dynotech-racing.com/partDetail.php?RefNum=2701

thx snoopmax......the mystery is finally solved! i'm gonna race a rc10 this winter. it will replace my xxx cr hehe.

Post a few photos when you've finished the car