Chassis id help needed
Posted: Tue May 11, 2010 5:48 pm
Hi complete newbie needs help!
Can anyone help identify this chassis?
Many thanks
Can anyone help identify this chassis?
Many thanks
RC10Talk - The Net's Largest Vintage R/C Community
Chassis id help needed
Page 1 of 1
Re: Chassis id help needed
Posted: Tue May 11, 2010 5:52 pm
composite craft, most likely.
Re: Chassis id help needed
Posted: Wed May 12, 2010 5:14 pm
Possibly JG Manufacturing (unless JG just sourced them from CC, which is entirely possible).
Re: Chassis id help needed
Posted: Wed May 12, 2010 5:27 pm
there were so many chassis' for the rc10 back in the day that looked almost identical it's rediculous. someone obviously added the cell slots, and it looks like it had a robinson racing adjustable rear toe setup on it at one time, too.
Re: Chassis id help needed
Posted: Wed May 12, 2010 9:03 pm
I am gonna bet it was mid motored at one point. It looks as though there are wear spots in front of where the bulkhead would be (that might also explain the extra rear holes as the bulkhead would have been moved to the rear) and why the cells are so far forward (because of the motor being in the way). My .02 -Jeff
Re: Chassis id help needed
Posted: Thu May 13, 2010 12:45 pm
Wow, thank you all for your input
This is a fantastic forum
This is a fantastic forum