RC10Talk - The Net's Largest Vintage R/C Community

Any of you out there have the Peak Performance Slipper Elimination/Direct drive kit for the Lazer? I need the dimensions of the fiber disc between the two pulleys. Center hole I can figure, but thickness, and outside diameter I'm lacking.

Thanks for any and all help on this.

This is this part:

Yep, that's it. I have everything but the fiber washer, it decided to take a trip during a recent preventative maintenance episode.

Whiskers wrote:Yep, that's it. I have everything but the fiber washer, it decided to take a trip during a recent preventative maintenance episode.

I hate when that happens. And if it ever shows up again, all you get is the "My washer went on a trip and all I got was this lousy T-shirt" shirt. I know, that was corny.

When you get the size, I would check at Lowes, see if they have a replacement. Good luck.

Fiberglass plate:

Outside 11 mm
Inside hole 4.5 mm
Thickness 0.75 mm

PRP

prp wrote:Fiberglass plate:

Outside 11 mm
Inside hole 4.5 mm
Thickness 0.75 mm

PRP

Thanks

I made a new spacer out of lexan, maybe it's not right, but it seems to work fine.

I'll be keeping my eye on it to see what it does, and how it wears.