RC10Talk - The Net's Largest Vintage R/C Community

I am in the process of getting my rc10T running. I need a couple of part numbers. I am looking for the dog bones. I saw in a previous link for the MIP cvd's but tower says they are discontinued. I am also looking for part for my stealth trans. The trans is complete. I have the first metal piece which slides onto the trans arm first. I do not have a spur gear or clutch. Pretty much need it all. Any help would be great.
Robert

you will find what you need here it has all the part numbers you want

http://www.theshreves.com/rc_stuff/rc10history.htm

Paul

Thanks for that link, I've been looking for the history and progression of the RC10. Most tell you this or that, but not everything.

i use these to

http://www.retromodelisme.com/home.html?

http://lowclasscc.net/downloads/

Where would I find a decal sheet? I know I can purchase the body from ebay, but can't seem to find a decal sheet.
Robert

well if you find some rc10 T decals let me know first they are pretty rare

Paul

treehugger wrote:well if you find some rc10 T decals let me know first they are pretty rare

Paul

good to know.. oh, well..

The tie-rods and the dogbones are the same as the SC10 (7253 and 7462). When I started my 10T rebuild, I was afraid that parts were going to be an issue. Really, they're not. The only 'non-original' part I am using is the body...I'm using an RC10T2 body. I think it looks better anyway. Between RPM and AE parts, I have replaced everything I had to.

wyattroa wrote:Where would I find a decal sheet? I know I can purchase the body from ebay, but can't seem to find a decal sheet.
Robert

i bought these and knowing they weren't originals. i was still a little disappointed in the low quality of some of the decals. they are better than none so they will do for now

http://oneofftees.com/zencartPGFX/index.php?main_page=product_info&cPath=2_19&products_id=111

sneako43 wrote:The tie-rods and the dogbones are the same as the SC10 (7253 and 7462). When I started my 10T rebuild, I was afraid that parts were going to be an issue. Really, they're not. The only 'non-original' part I am using is the body...I'm using an RC10T2 body. I think it looks better anyway. Between RPM and AE parts, I have replaced everything I had to.

Correction, the dogbones are not the same.

Oh, and I guess the RPM parts I'm using aren't original, either!

Yeh the SC10 dogbones and or driveshafts are cpl mm longer than 10T. Part no 1082 at tower for cvd's