RC10Talk - The Net's Largest Vintage R/C Community

http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LX2511&P=M

Can these arms be used on a "Old is New" project instead of the Dynotech arms?? will it give me similar results??

Thank you.

those are the stock wide arms. they are made for the standard buggy nose plate and bulkheads.

the dynotech arms are about 1/4" wider and are made for the rc10t nose plate and bulkhead.

so it depends on what setup you are using. the stock arms wont fit the truck bulkhead and the dynotech arms would be too wide using the buggy nose plate.