RC10Talk - The Net's Largest Vintage R/C Community

I picked this up yesterday for $35 and need help to figure out what it is. Thanks for the help.

Looks like a Rustler chassis to me...

yep.

Thank you for the help on this.

Definatly an earlier rustler, but not an early early one as yours does have the slipper clutch on it which is a plus!

I have been away for a little bit, could you tell me what else is needed to complete this truck.

going to need a front batterie strap, radio, reciever, speed control, posibly a front camber link (the one with zip-ties looks to have been repaired?) battery & charger. Maby a new bodie as well. That one doesnt look like it fits all that well.
Id also recomend converting over to ball berrings if that hasnt been done yet & a RPM bumper. As things brake replace them with RPM parts (front & rear arms, caster blocks, camber links, etc.

airdreams1 wrote:going to need a front batterie strap, radio, reciever, speed control, posibly a front camber link (the one with zip-ties looks to have been repaired?) battery & charger. Maby a new bodie as well. That one doesnt look like it fits all that well.
Id also recomend converting over to ball berrings if that hasnt been done yet & a RPM bumper. As things brake replace them with RPM parts (front & rear arms, caster blocks, camber links, etc.

Thank you for your help, this is my only electric car at the moment and I wanted to make sure I picked up everything at once. Also I have replaced the front camber link since this picture. Looks like I will be off to my local hobby shop to finish it up. Thanks again.

definately early rustler.i have parts laying around for this if you need.