Page 1 of 1
Tamiya Lexan Brat Body info needed
Posted: Sat Aug 28, 2010 11:05 pm
by drbelleville
Anyone with a Tamiya Brat lexan body, can you tell me the width at the wheel wells, and also the wheelbase?
Thanks
Re: Tamiya Lexan Brat Body info needed
Posted: Sun Aug 29, 2010 1:58 pm
by airdreams1
If i remember correctly they are about 7" fender to fender & just under 10" wheel center to center
hope that helps or maby someone has one in hand that they can meisure...
Re: Tamiya Lexan Brat Body info needed
Posted: Sun Aug 29, 2010 4:27 pm
by Y'ernat Al
The wheelbase is 248mm or about 9.75 inches. Fender to fender may depend a bit on how you cut it right?
http://www.tamiya101.com/model_info.asp?id=38
This site has vital stats on all the Tamiya vehicles.
-B
Re: Tamiya Lexan Brat Body info needed
Posted: Sun Aug 29, 2010 4:45 pm
by drbelleville
Well that is true but I am curious if you were to cut it as it was meant to be cut, what is the width going to be. I am building a chassis, and thought the Brat would be a good fit, although I need those dimensions to be sure.
Thanks.
Re: Tamiya Lexan Brat Body info needed
Posted: Mon Aug 30, 2010 3:34 am
by airdreams1
16.5" Length
6.75" Width
10" Wheelbase
thats what I got from tamiya