Page 1 of 1
Kyosho 'guru' needed - HELP!
Posted: Sat Sep 04, 2010 2:33 am
by Bormac
Ok so that got your attention. I dont have a manual to check part numbers but Im after new ball sockets for cars like the Optima, Ultima etc...Can you tell me if these are the right part#
http://cgi.ebay.com/Kyosho-5-8mm-Ball-End-LA43-/170533041421?pt=Radio_Control_Parts_Accessories&hash=item27b48fb50d
Re: Kyosho 'guru' needed - HELP!
Posted: Sat Sep 04, 2010 3:42 am
by aip47-2008
LA-43 is listed as a Lazer zx part, but is the same 5.8mm end as used with the OT-35 ( Upper Rod Set) that the Optima, Optima Mid, Turbo Ultima, and many other Kyosho kits used. I hope this helps you Jason.
Kyosho USA still shows OT-35 as still available!
http://www.shopkyosho.com/products/productdetail/part_number=OT35/410.0.1.1
http://cgi.ebay.com/OT-35-Upper-Rod-Set-2-Optima-Ultima-Stinger-Maxxum-/250689788364?pt=Radio_Control_Parts_Accessories&hash=item3a5e4699cc
Aaron
Re: Kyosho 'guru' needed - HELP!
Posted: Sat Sep 04, 2010 8:36 am
by Bormac
Thankyou Aaronm you are a great help.
Re: Kyosho 'guru' needed - HELP!
Posted: Sat Sep 04, 2010 9:34 am
by Bormac
While Im asking questions concerning old Kyosho stuff Im also looking for coild to fit the Option House 'GOLD' shocks. I dont necassarily require OEM coild but wondering if the ZX5 coils are the same diameter?
Re: Kyosho 'guru' needed - HELP!
Posted: Sat Sep 04, 2010 11:47 am
by mikedealer
Re: Kyosho 'guru' needed - HELP!
Posted: Sat Sep 04, 2010 11:48 am
by mikedealer
i have some interchange parts on my unfinished kyosho blog also
http://kyoshoparts.blogspot.com/
Re: Kyosho 'guru' needed - HELP!
Posted: Tue Sep 07, 2010 12:41 am
by Jay Dub
The newer Kyosho ball cups you listed are the same size as the old cups, but have a matte finish instead of a gloss finish as on the Optima/Ultima/Lazer series of cars. As for the Springs, I just tried my ZX5 FS springs (yellow orange if you must know
) on a set of Kyosho Golds, and they fit just fine. Nominally smaller because of powder coating though. -Jeff