RC10Talk - The Net's Largest Vintage R/C Community

Hi guys,

Having a bit of a transmission issue with my 10T

It's been sitting for a while and I purchased a Mamba Max for it brushless system and it runs great, now however when I put the truck down on the ground it seems to barely go at all...essentially it creeps. However, when I pick the truck up and gas it the tires spin like hell...any ideas on the problem?

Sounds like either your diff is loose or the heat generated by you last run melted the diff gear

Negative on it being lose, and the diff isnt melted.

Possible slipper clutch?

Then, your other possibilities are-

1) split wheel on either side allowing the axel to spin inside the wheel it should be turning
2) missing or broken drive pin
3) spit slipper pin
4) glazed slipper pads
5) incorrect slipper arrangement