2.2 CVD equiped yokomo 870c
Posted: Wed May 23, 2007 11:57 pm
That headline had to get some attention! 
I think I have it figured out though, I did a quick and dirty fitment and it looks like the parts I have pieced together are going to work! I'll post some details and pics when I get it finalized and some parts made that look like I spent more than two minutes at the lathe.
My main question though is do you think it would be okay to have .200" more track width to the car front and rear (.100" per side)? I know it will put just a bit more load on the hub bearings front and rear, and add a bit to the scrub radius in the front but other than that does it seem okay?
ford
thanks again tulsa and shodog!
I think I have it figured out though, I did a quick and dirty fitment and it looks like the parts I have pieced together are going to work! I'll post some details and pics when I get it finalized and some parts made that look like I spent more than two minutes at the lathe. My main question though is do you think it would be okay to have .200" more track width to the car front and rear (.100" per side)? I know it will put just a bit more load on the hub bearings front and rear, and add a bit to the scrub radius in the front but other than that does it seem okay?
ford
thanks again tulsa and shodog!