RC10Talk - The Net's Largest Vintage R/C Community

Okay Im am currently doing a whats old is new build with the dynotech arms front and rear. Can someone please tell me what the turnbuckle legnths that I need are, from what I understand the dynotech arms are the Worlds length, which I am told are longer than the usual rear a arms for the gold tub.

there is too many variables: ball stud placement, ball end length, etc.

set your car up the way you want with used tie rods, measure them, then get the length you need.

I think I used these Lunsford lengths with RPM ball ends:

2 - 1 7/8
2 - 1 1/2
2 - 1 3/4