RC10Talk - The Net's Largest Vintage R/C Community

Well, today I re-aquired a box of old rc stuff I gave my nephews about 8 years ago. I was lucky to find the things I did, but am in need of a few parts to finish them off. First is an MIP SP-1 (I think). I found almost all of the parts rolling around in a REALLY dirty box. I only (luckily) need an idler gear, a slipper plate, and the slipper tension spring. Other than that it's complete. Question is, what type of idler gear do I need? The ohter gears are brass, and I seem to remember it was too? I also assume the slipper is going to be hard to find plates for, as I have never seen another one . -Jeff

I've seen idler gears in steel brass and plastic so take your pick. FYI sand scorcher idler gears work.

Cool, thanks for the help. BTW you have any spares? Since you are local and all . -Jeff

I may have a gear but not the slipper

MIP #SL-4 is the part you need for the slipper spring, washer and adjustment screw, and L-3 is the correct part for the slipper pads. I already sent you a link, and I can help you with everything you need as well!

Aaron