RC10Talk - The Net's Largest Vintage R/C Community

Does anyone know what the bearing size would be that replaces the felt seals #6633 and retainers on a six speed tranny. I came up with 3/8 X 5/8 http://www.avidrc.com/product/1/bearings/62/38-x-58-Revolution-R1038-RSZ-bearings.html, but I'm sure no math wizz with a caliper.
Thanks for the help !!!

Craig

Those are the ones.

Wow! A six speed tranny, I haven't seen one of those before? Was that an aftermarket setup?

They can't be that rare as I see them listed all the time on eBay as one.

Make sure you get your spelling right. These guys on RC10Talk with pick you apart.

Thanks for the help rctenracer, I thought that was what this thread was for, help.

Hey - If making fun of me. makes them feel better about themselves, then more power to them. I wish I was perfect !!!

Hey, don't take offense. We have a pretty tight knit group of individuals here and are on more of a "good friend" basis than you will find on other sites. We enjoy talking, sharing, and helping each other. We are "hard" on each other because we care and enjoy ribbing each other, not because we are a-holes. There was no malice intended, and I appologize if you were hurt. I guess I thought a Raider fan would be used to it (JK). -Jeff

BTW -"JK" means Joke. (don't want to offend you twice).

i wonder what top end you would get out of a 6 SPEED* i know my tf2 with the two speed trans is Fast (lipo and BL no control what so ever but fun. As no brakes with the two spurs .


* not meant as joke just a honest Q