RC10Talk - The Net's Largest Vintage R/C Community

I know you can buy these in packs of four quite cheaply but is there anywhere you guys know of that they can be purchased in bulk, say 20 or so?

i picked up a 1mm x 12mm? oring from mcmaster-carr that seems to be a good replacement. I can't remember the exact size, I'll double check when I get home and let you know.

I think 100 of 'em was less than 5 bucks (plus like 5 shipping, but I always order a bunch of stuff, so my shipping gets distributed through a bunch of things)

Thanks. I must be able to find them over here somewhere but to no avail at the moment. Maybe i'm just not looking hard enough!

yeah, you have to be able to do a simple internet search and find a number of places that can sell you metric o-rings

I think i've found, some was 1 mm x 12mm the right dimensions?
Did take a while to find somewhere thou.

yeah, i think that was right. I measured the OD as around 11.5, so it's probably a 12mm, and the thickness was 1mm.

Thanks for that

I think they had the x-ring shaft seals also. Ive seen them mentioned on different boards as a replacement for the AE seals that seem to leak alot.
http://www.mcmaster.com/#6540k116/=b7a2tw
http://www.mcmaster.com/#90025k123/=b7a26l

Nick

Thanks for your help guys i now have a good supply of both types of o rings winging they're way to me. Should be enough there for years of shock rebuilds

For anyone in the U.K reading this thread they were ordered from:

http://www.polymax.co.uk