RC10Talk - The Net's Largest Vintage R/C Community

I was running the xcelorin 17.5 set up in my b4. It was running fine with my am radio setup. I got a new 2.4 ghz system, switched the parameter on the software to that and also updated the firmware. Now when I try to calibrate it to the new setup the yellow light stays on constant and won't calibrate. Any body else have this problem? I haven't contacted Losi yet I plan on doing that tomorrow.

Alright I just said screw it and dropped some change on a Tekin rs. This thing is awesome. Soldered the wires on programmed it without the firewire and it screams right out of the box. I think I found my new brand Team Tekin. I have to send in the xcelorin and get it fixed,after I do that I will trade it or sell it.