Page 1 of 1
What are these holes for?
Posted: Mon Jun 25, 2007 3:01 pm
by Synergy
This was a recent Ebay win, all I saw at time of bidding was a nice A chassis, I didn't notice the holes that were obvious to see on further inspection
, how does that happen
Anyway I guess they're for Nerf bars, the distance between the holes is 75mm center to center, can anyone show me what should fill the gap
Thanks.
Posted: Mon Jun 25, 2007 3:16 pm
by Tadracket
Wow, that is a clean looking chassis. Was it built or what?
Posted: Mon Jun 25, 2007 3:22 pm
by Synergy
No just the chassis.
Posted: Mon Jun 25, 2007 3:35 pm
by shodog
Looks like the ones on the side were drilled by the previous owner but do the others have annodizing over them and are they countersunk?
Posted: Mon Jun 25, 2007 3:41 pm
by Synergy
They're not all countersunk but they are all fully anodized except the ones on the sides, which were the ones I was wondering about.
Posted: Mon Jun 25, 2007 5:01 pm
by Asso_man!
maybe for some kind of cross-stiffeners
Posted: Mon Jun 25, 2007 5:07 pm
by scr8p
proline made white plastic nerf bars, to go along with their front and rear bumpers. but i don't remember them being quite that long.