RC10Talk - The Net's Largest Vintage R/C Community

hey guys, here is a car i used to own, then gave it to a mate before I overseas...i managed to get it back again last week...and still in near-new condition.

just cant remember what model it was...YR4 somthing.

still got the old Mr.? in it and old pack of scr 1400's I think...though sad to see the old novak hammer is gone :/

That`s the YR4 M2 I think, I might have wheels and tires Yokomo for it.

mamadoesn`tletme wrote:That`s the YR4 M2 I think, I might have wheels and tires Yokomo for it.

I thought it was the M2, but googling i couldnt find any pics, only pics with the larger shocks, im thinking I have an early M2 perhaps

Hi, yes its a Yokomo YR-4M

Here's a review I uploaded for someone else a short while ago...

http://img135.imageshack.us/img135/4237/yr4mreview1.jpg
http://img546.imageshack.us/img546/4774/yr4mreview2.jpg
http://img87.imageshack.us/img87/8986/yr4mreview3.jpg
http://img689.imageshack.us/img689/8350/yr4mreview4.jpg

this is YR-4M........

for the M2........it has the adjustable 3+3 battery trays.......and chopstick-like upper deck.........

since that time........Yokomo started to realize "the tricks of earning $$"........they changed the car spec every half year........with YR-4 II.......YR-4 M2........type-J......type-J Pro........bla bla bla.........

this is the YR4 M2 Type J:

Guys,

Need to ask you somethings, will this motor mount fit my 91 Works?

ZR304J2 Yokomo Aluminum Motor Mount for YR-4M II Pro

will this be a direct fit or i should just drop it.

thanks,

will this motor mount fit my 91 Works?

If I am not mistaken....I think the screws where you bolt the motor mount to the chassis would be too small for the 91 works (3mm as oppose to 4mm?)

Hi, the ZR-304J2 motor mount will not fit the 91 Works sorry, you'd need the ZC-304S, ZD-304S or an aftermarket early YR-4 type mount

uzzi wrote:If I am not mistaken....I think the screws where you bolt the motor mount to the chassis would be too small for the 91 works (3mm as oppose to 4mm?)

I am not aware of a Yokomo motor mount that uses M4 screws they are all M3 as far as I know

Thanks YZ-10, so the search is on...... cant seem to find one....