RC10 Tube Chassis Prototype
Posted: Sat Jul 14, 2007 2:48 pm
finally got some pics of my build going and wanted to post them up here as i build them.
keep in mind this is just a prototype so forgive the crappy welds, they will clean up nicely anyway. i used 3/16 stainless tube (the coated stuff gives off toxic fumes lol) and some 45 silver brazing wire & white flux.
i built a b4 chassis with same tubes and it stands up really well against bashing and hard hits if built strong enough.
its only about 1/3 done, but wanted to post up before i get lazy again.
keep in mind this is just a prototype so forgive the crappy welds, they will clean up nicely anyway. i used 3/16 stainless tube (the coated stuff gives off toxic fumes lol) and some 45 silver brazing wire & white flux.
i built a b4 chassis with same tubes and it stands up really well against bashing and hard hits if built strong enough.
its only about 1/3 done, but wanted to post up before i get lazy again.