RC10Talk - The Net's Largest Vintage R/C Community

Are these the correct rear carriers for the 91 / 92 "works"?

Aaron

I can't believe that you can find this, aaron. my works'91 come with this part but I can't find any information about this hub carrier,they directly fit.

I don't have any memory on the hub carriers. 3rd party?

I bought them in a Yokomo parts lot from the UK. The buyer told me they looked just like his 91 rear carriers on the shelf. But I have never actually seen a good picture of these before!

Apparently they are quite rare / hard to find!

crusaderlyf wrote:I can't believe that you can find this, arron. my works'91 come with this part but I can't find any information about this hub carrier,they directly fit.

yokomo works'91 01.JPG

Incredible example you have there Yunfei

Thanks for the picture.

Aaron

aaron 91 are different from 92/93 from memory. never seen the one's you have, very

these are 92/3

AFAIK, 91/92/93/94 are all the same except later ones may have come with 2 holes for mounting to the arms (hi/low). The ones you have are sks or something. I have a set somewhere.

Nice

I believe I have seen a pic of a Masami car with those rear carriers on it before...Just dont remember which one it was...I bid on a parts lot with some of those carriers in it, a few months back but sadly I did not win it.

I'll have to look for that pic now.

fakiee wrote:AFAIK, 91/92/93/94 are all the same except later ones may have come with 2 holes for mounting to the arms (hi/low). The ones you have are sks or something. I have a set somewhere.

Nice

they are the same hey alway's something to learn

Found it Masami's works 91 car

Justjoe wrote:Found it Masami's works 91 car

nice find

Just to clear up which Yokomo came with the rear unique hub carriers that Aaron has posted, it is the Yokomo Works '91.

The Works '92 (essentially the same chassis speciafications as the Works '91 albeit with some running changes) used the same rear hub carriers that were used for the Works '93, WCS, 94 YZ10 and Pavidis YZ10.

Again, these hub carriers were only used on the Works '91 and are hard to find because Yokomo changed the design quite quickly to the newer design hub carriers.

Vin

THANKS TO ALL WHO HELPED ME IN THIS THREAD


This forum proves daily why it is, and by far the best!!!!!!!!!!!!!!!!!!!!!!

Aaron if I`m not wrong I have the rear ones in case you need them.

tamiya_d1_junky wrote:

fakiee wrote:AFAIK, 91/92/93/94 are all the same except later ones may have come with 2 holes for mounting to the arms (hi/low). The ones you have are sks or something. I have a set somewhere.

Nice

they are the same hey alway's something to learn

I thought they were the same! And yes there is always something out there that surprises me when it comes to RC, I'm happy to never stop learning