Page 1 of 1
JRXT question
Posted: Tue Aug 09, 2011 8:19 pm
by KV78
I have a JRXT with the extra wide RPM h-arms on the rear. I want to put CVD dogbones on it. Will the dogbones from the LXT work on it?
Re: JRXT question
Posted: Tue Aug 09, 2011 9:35 pm
by KV78
OOOOR will the cvd's MIP-200 fit?
Re: JRXT question
Posted: Tue Aug 09, 2011 10:55 pm
by Charlie don't surf
The lxt set should be fine, as long as you are using the 2021/2038 hubs
Re: JRXT question
Posted: Wed Aug 10, 2011 1:22 pm
by highwayracer
The Jrxt RPM wide truck arms are much narrower than the stock LXT arms...and they use the same hubs. What transmission will you be using?
XX retrofit
Stock 6 gear with dog bone outdrives
MIP
Each transmission will require a different dog bone length. I had to make spacers (between the plastic yoke and the mip bone) to get the right length.
Regards,
highwayracer
Re: JRXT question
Posted: Wed Aug 10, 2011 11:36 pm
by KV78
I have the LRM trans with some MIP outdrives. I have the whole MIP kit but it's for the stock 5 link and it won't reach. lol Can you post a pic of your spacer....I didn't even think of that.