Page 1 of 1
CVD's to fit Pro SE?
Posted: Thu Sep 22, 2011 4:25 pm
by Caine
Just been asked this question by a fellow racer from my club who's trying to get his JRX Pro SE up togeteher for our vintage series.
' Are there any available CVD's that will fit the Pro SE? '
Thanks
Re: CVD's to fit Pro SE?
Posted: Thu Sep 22, 2011 4:41 pm
by aconsola
mip did make a set for the jrx-2. the pro-se has the same basic suspension geometry in the rear, so they should fit if he is using the original transmission.
as for modern cars from which to retrofit cvd setups, I'd like to know that as well as the JRX-2 parts are usually hard to find.
Re: CVD's to fit Pro SE?
Posted: Thu Sep 22, 2011 5:34 pm
by Caine
Hmm, thanks for the quick reply
Seems like i have stepped over to the darkside! I'm pretty sure about associated stuff but now i'm getting into the losi side of things i dont know anything!
Re: CVD's to fit Pro SE?
Posted: Thu Sep 22, 2011 6:26 pm
by losiXXXman
Jake (Bigjeepz) recently machined some bone outdrives for the LRM that would take Associated CVDs.
http://www.rc10talk.com/viewtopic.php?f=27&t=23271
Shoot him a PM and see... cannot hurt to ask.