RC10B4.1 Flat head screw degree?
Posted: Fri Sep 23, 2011 8:16 pm
I'm looking to replace the flat head screws on the bottom of my B4.1 with phillips head flat heads. Anyone know what degree the flat heads are (82 or 100)?
RC10Talk - The Net's Largest Vintage R/C Community
RC10B4.1 Flat head screw degree?
Page 1 of 1
Re: RC10B4.1 Flat head screw degree?
Posted: Sat Sep 24, 2011 12:08 am
82
Re: RC10B4.1 Flat head screw degree?
Posted: Sat Sep 24, 2011 12:21 am
Stupid question, but do you have to buy special drill bits to countersink for Associated (or any) screws? If so, what's the source? My countersinking sucks. 
Re: RC10B4.1 Flat head screw degree?
Posted: Sat Sep 24, 2011 12:25 am
If you are using a CNC router then the answer is yes ( kinda ) because it drills and then countersinks with the same bit. If you are doing it by hand, then no- all you have to do is drill the correct size hole and countersink it with the correct degree bit ( to get the head to fit flush)
Re: RC10B4.1 Flat head screw degree?
Posted: Sat Sep 24, 2011 6:41 am
Thanks.