Page 1 of 1
Gearing suggestions on Yz-10
Posted: Tue Nov 08, 2011 1:15 pm
by DJGonzo69
Hi All,
Just wanted to know if yu guys have any gearing suggestions on the YZ-10 if using a 17.5, 10.5 & 5.5 Brushless motors. Also what is the gear ratio of the Yoke is is 2.25?
Thx,
John
Re: Gearing suggestions on Yz-10
Posted: Tue Nov 08, 2011 4:15 pm
by slotcarrod
Looking for this info myself!
Re: Gearing suggestions on Yz-10
Posted: Thu Nov 10, 2011 1:11 pm
by DJGonzo69
I just found out the gear ratio of the Yoke...it's 2.2
Re: Gearing suggestions on Yz-10
Posted: Thu Nov 10, 2011 4:02 pm
by slotcarrod
Cool thanks!
Re: Gearing suggestions on Yz-10
Posted: Thu Nov 10, 2011 4:52 pm
by scr8p
2.33 according to an old twister gearing chart......
Re: Gearing suggestions on Yz-10
Posted: Thu Nov 10, 2011 5:54 pm
by Charlie don't surf
Maybe the difference is the 3mm vs 2mm belts and pulleys? There was a 33t and 35t diff pulley option for the 93 and up in 3mm, and a 15/16 center pulley
Re: Gearing suggestions on Yz-10
Posted: Thu Nov 10, 2011 6:21 pm
by DJGonzo69
33 Tooth Pulley / 15 Tooth Center Pulley= 2.2
The variations might be on the different pulleys used.
I will have to recount the pulleys to be sure.
Re: Gearing suggestions on Yz-10
Posted: Fri Nov 11, 2011 12:28 am
by Justjoe
The early YZ10 was 2.33. Mine came with the 35 tooth diff and 15 tooth center pulley. Not too sure what the 91/93 works cars came with.