Page 1 of 1
Tekin small red and black wire?
Posted: Thu Dec 01, 2011 12:06 am
by slotcarrod
I need your help! I have an older Tekin, not sure what it is but it says Pro Tempfet ESC on the label! Anyway I am putting it in a 4 cell RC12L and can't remember if I solder the tiny red and black wires together for 4 cell use, or not?
Re: Tekin small red and black wire?
Posted: Thu Dec 01, 2011 6:10 am
by caesar
Here is a link to all the old tekin esc
http://www.teamtekin.com/archive.html
The pro tempfet manual is there.
Hope it helps
Cheers
Rob
Re: Tekin small red and black wire?
Posted: Thu Dec 01, 2011 6:12 am
by Asso_man!
Yes, you have to join these two tiny wires for 4-cell use!
Re: Tekin small red and black wire?
Posted: Thu Dec 01, 2011 6:16 am
by caesar
Just looked it up in the manual.
"4 Cell Option; run a jumper wire from the black switch wire to the red receiver wire in order to bypass the regulator. Do not connect to more than 4 cells after doing this. This modification is required for proper 4 cell operation"
Re: Tekin small red and black wire?
Posted: Thu Dec 01, 2011 11:29 am
by slotcarrod
That's perfect information! Thanks guys!
I didn't know Tekin had an archive, that may come in handy later as well!
