RC10Talk - The Net's Largest Vintage R/C Community

My plan is to build a runner. I plan to use old aftermarket parts, but going brushless. I whant it all black.
This is the start.

That almost looks like a finished runner. Great start!

Better get some rit dye i see some white looks good

I dont dye. It gets to ugly when it is used.

what rear wheels and hexes????

i am using b4 hubs/wheels and b44 cvds but the rear track is narrow.

Don´t whant to use to much new parts. I think the slipper is enough.
I´m planing to use Kyosho or Hong nor wheels with the hexes.
Orderd the hexes from Ebay.

aurell wrote:Don´t whant to use to much new parts. I think the slipper is enough.
I´m planing to use Kyosho or Hong nor wheels with the hexes.
Orderd the hexes from Ebay.

She looks great!

Someone makes adapters to go from RC10 to hex wheels? Who?

HPI makes 'em. I would have to search for the part #, but Tower and other LHS usually carry them.

CUDDZILLA wrote:

aurell wrote:Don´t whant to use to much new parts. I think the slipper is enough.
I´m planing to use Kyosho or Hong nor wheels with the hexes.
Orderd the hexes from Ebay.

She looks great!

Someone makes adapters to go from RC10 to hex wheels? Who?

Here is mine. http://cgi.ebay.com/140550780224#ht_1009wt_952
Perfect fit om my car.

This is how it looks now.

What front wheels are those and are they direct fit. What about track front and rear?

I think those are Peak racing wheels, available back when the RC10 was still being produced.

The wheels were labeled Procar in Sweden.