RC10Talk - The Net's Largest Vintage R/C Community

I just mounted up my front suspension with Klein arms and the longer GT front shaft. My stock RC10 inner hinge pin mount was too narrow for the Klein arm so I used a spacer (about 1/4" thick).

What is the correct hinge pin mount to go with the front Klein arm?

for the klein front arms you need rc10t nose plate, bulkhead, and hinge pins. the stock rc10 nose plate is too wide and the mounts/hinge pins are too small for the klein arms.

Check my reply to the same question in the post below.

http://www.rc10talk.com/viewtopic.php?f=38&t=25150&start=15