RC10Talk - The Net's Largest Vintage R/C Community

Disc springs... What's the consensus on how many to use? Procat manual shows 2, but I believe some people use 4.
Where can I get a Procat front belt, any ideas? -It's the last piece in the jigsaw for my car (though my U/J's are very worn).
-Jools

you mean spring washers?

I use three. Like this ()(

Jools wrote:Disc springs... What's the consensus on how many to use? Procat manual shows 2, but I believe some people use 4.
Where can I get a Procat front belt, any ideas? -It's the last piece in the jigsaw for my car (though my U/J's are very worn).
-Jools

I belive Luke are using 4 .

belts can be bought from

http://www.sdp-si.com/

they also stock alu pulleys that can be used...

mvh Isobarik

Don't suppose anyone knows the SDP part no for the front belt for the Procat?
(I'm a little confused about the correct pitch / tooth profile)
-Jools

324 mxl pitch

lovely orange

have you looked at http://www.oople.com

under forums / vintage there is an thread with al the mods that luke has done to his procat

happy reading

mvh Isobarik

and yes there is an link at the page.......

The Procat belt is MXL 323T 4mm neoprene but I'm using 320T 6mm wide.

I think this is the closest they do but it is 4.5mm wide...



Lots of info on my Oople thread for you too.

The guru him self.

mvh Isobarik

Cheers for the heads-up Luke, ordered a couple of Belts.
-J