RC10Talk - The Net's Largest Vintage R/C Community

Hey Guys, anyone have a copy of Jammin' Jay's tranny rebuild? Mines in storage....somewhere.....Thanks Johnny

this one?

http://www.rc10talk.com/viewtopic.php?f=80&t=3748

Is this the one?
http://www.rc10talk.com/viewtopic.php?f=80&t=3748

Thanks Guys, now to print it off and on to two full bearing trannys Edit; do you guys drill and set screw the 3/8X5/8 or glue??????

rc10johnny wrote:...Edit; do you guys drill and set screw the 3/8X5/8 or glue??????

Neither. I use Jammin Jay diff tubes with squared off drive rings.

Sorry! 3/8X5/8 bearings on diffs.....JohnnySr

Ahh you mean on the outdrives? Thought you were talking about pinning the drive rings.

On one side the motor plate holds in the bearing but on the other side I didn't glue or use a screw. I thought the screw was only for when doing the bearing elimination mod since without the screw the outdrive had nothing holding it in. Since I eliminated the bearing inside the outdrive a little differently I didn't need the screw outside the case to hold in the 3/8x5/8.

Thanks Phin!

I haven't raced a 6 gear car in over 20 years, but I always used blue locktite to set the rings. Some other guys used CA glue. I always thought the set screws would unbalance the gear.