Shodog's MIP 4wd SRB project
Posted: Mon Jun 18, 2012 9:18 pm
I've had these thoughts swimming around my head for a couple of years. I've always wanted to combine a MIP 4-10 kit with a fully hopped up Rough Rider SRB chassis. I needed to do some R&D with parts to see if my idea would work. So before I start ripping into new parts packages, I took apart my MIP RC10 and MIP Scorcher and test fit some parts and it looks like it will work. I need to add about 60mm to the width of even the RCH wide track front tubes.
Here is the body I plan to use. It's from a previous hopped up SRB build. The chassis was assimilated into other projects or sold off but I kept the body.
I may need to do some judicious trimming depending on which roll cage I go with
RCH Front suspension that I had annodized red
Rear suspension is an MIP trailing arm kit with MIP drive shafts and CRP axles
I have some vintage Kyosho dampers from the circut 1000 buggies with some CRP collars.
Transmission is a Hot trick transmission mount and a MIP transmission with ball diff and 4WD outdrives.
Of course a set of Tecnacrafts to finsh off the red theme
Here is the body I plan to use. It's from a previous hopped up SRB build. The chassis was assimilated into other projects or sold off but I kept the body.
I may need to do some judicious trimming depending on which roll cage I go with
RCH Front suspension that I had annodized red
Rear suspension is an MIP trailing arm kit with MIP drive shafts and CRP axles
I have some vintage Kyosho dampers from the circut 1000 buggies with some CRP collars.
Transmission is a Hot trick transmission mount and a MIP transmission with ball diff and 4WD outdrives.
Of course a set of Tecnacrafts to finsh off the red theme
), that is some dead sexy stuff right there. Your builds always amaze me! I actually just browse your gallery when I'm blue 
.
