RC10Talk - The Net's Largest Vintage R/C Community

Anybody happen to know the bearing size at the end of the center clutch assbly (also reffered to as the center one way bearing - maybe?) looking at the one at the opposite end of the spur gear. Any help is greatly appreciated.

Also looking for a part number or dimensions on the tiny diff balls that go in the drive outputs.

And last but not least i need a part number and source for the 7mm hex bolts that hold the turn buckles in place top and bottom.

My resto is humming along - cant believe how nice the metal bits clean up with a wire brush and dremel.

Tom

The ball bearing in slipper pad is 5x8mm

crusaderlyf wrote:The ball bearing in slipper pad is 5x8mm

Awesome thanks crusader!!

Any chance you know what size the tiny diff balls are in the out drives?

OldSkoolRC wrote:

crusaderlyf wrote:The ball bearing in slipper pad is 5x8mm

Awesome thanks crusader!!

Any chance you know what size the tiny diff balls are in the out drives?

sure,thrust balls is 1/16 as many cars.

Thanks again crusader!

Since you really know your yokes, any chance you can direct me to a source for a rear drive belt for the yz10/870c?

Any help is really appreciated.

Tom