RC10Talk - The Net's Largest Vintage R/C Community

Had a dead brick so I figured i could re-pack it. Looks pretty original from the outside. I left the heatsink in place for looks, the speed control inside should be OK as its a very mild stock motor. If it gets hot I may have to get creative

Good idea - nice job

Was the hole on the top suppose to be for a crystal?

Yes, and it will get half of one when I button this project up

why dont u get a el cheapo brushless esc fan and dremel a few vent slots on the case
mite work!
farmer
ps. where r those mini pins

Do you still have the original electronics inside the brick? Or pictures.
I would be interested to see what they used that time.

ill have to dig through some stuff and see if I kept it. The wires were all chopped off so I assumed it was probably dead

Neat! It looks like you have room to put a fan in there in front of the RX.

Very cool Jeff! When I was going through my early Digger phase I considered doing this. I still want to make a nitro Digger with the nitro version of this chassis one day. One of these days...

Jeff
did you find the old electronics from the brick?

Sadly it has not turned up. I suspect I dumped it as it was chopped and claimed not working