RC10Talk - The Net's Largest Vintage R/C Community

Hello All, I recently acquired a Turbo Inferno. I would like to drive this car like I stole it but I am concerned about breaking the arms. Does any one know if the arms from any of the other series fit? Maybe from the MP5 or MP6?

I don't believe that they will fit...I know that the suspension pivot pins are a different length. 67mm for the Turbo and 63mm for the MP5/MP6.

There´s a set of BS 56 on ebay right now.

Thanks a lot guys. I guess if I am going to drive this car I will have to be more careful.

Those arms are pretty hefty...but I've broken some before. A concrete parking lot barrier is a lot harder that plastic

I checked the mp5/6 arms and they're just a little bit too long. The rears aren't that bad, but the fronts are just too far out.
How many sets of arms are you looking for? Can they be used?

You can also boil the inferno arms to make them a little bit more flexible/less brittle.

My car is complete without any broken parts. I would like to have another set just in case I break one. I do not intend to have a shelf queen. I am not racing this car but I do intend to drive it and things happen.