RC10Talk - The Net's Largest Vintage R/C Community

Is this an good idea to make.
Will try tomorrow to make an pair.
Thoughs.....
Jerzi

I think it would look pretty sweet. Might need some braces along the edges of the plates so they don't spread apart like the stock metal ones do.

Will do four more parts.
Pics will follow up tomorrow.
Jerzi

Something is ready.
I have some hop up parts to this car that ill put in.
Robinsson gears and drive axels for example.
Jerzi

Very nice! Those would be an ideal blank canvas for a custom transmission too

That's pretty sweet. It would look great with a custom trans, battery plates, front and rear shock towers. I'm going to follow this build for sure.

Nice job... how did you make that? Do you have access to a CNC machine?

How thick is that material?

I'm not sure if he is using a CNC or not, but if you are making a one-off copy of the metal plates a pin router will do just fine I have a thread here if you search "pin router".

The carbon plate is 2.1mm very high quality stuff.
Go to kyosho and there youll finf LA SCORPIONE VERSIO CARBON and there is an dirct link to my site where I have showed how I do the parts.
I use the original parts as blueprint and uses dremel and special tools to work with.
Jerzi

More pics.
Jerzi

Very nice. Now it needs a pair of alloy trailing arms.

Will put these parts in the car.
Jerzi

The transmission have got now new gears and driveshaft.
Jerzi

Oh man that is looking good.

Will do a copie of the crp motor plates of carbon and then put it together and wolaa it is ready.
Jerzi