RC10Talk - The Net's Largest Vintage R/C Community

just wondering is there a way to program hobbywing esc without the program card mines in lipo mode . and i only use nimh . i can get a minute or so then goes to low voltage cutoff . i hve the instructions watched the you tube videos . just cant seem to get it to program maybe im missin some thing. also if anyone hs spre program card im interested any help will be appreciated

Which Hobbywing?
http://www.hobbywing.com/product.asp?bigclassid=13&subclassid=45


There are 2 types of programming cards LCD and LED, and you should be able to adjust them manually.
http://site.hobbypartz.com/hobbywing/HW-13-V2.pdf

If all else,
http://www.rctech.net/forum/electric-off-road/507750-hobbywing-tech-support-1-8-1-10-off-road.html


MOmo

I seem to remember having a similar problem with a Hobbywing re-brand in my Barney project. The ESC would work with a NiMH battery for a few brief moments, then shutdown. When I put in a charged LiPo, it worked fine. I think the problem might've been the NiMH battery, it had been sitting awhile after a full charge but NiMHs kind of leak out their charge over time. I wish I could help further but without a look at the instruction booklet, I can't help more than to say I had that exact same problem.