Page 1 of 1
Gear cover RC10
Posted: Mon Mar 25, 2013 12:44 pm
by PKKC
Hi, I have been searching the old posts but couldn't find the answer I needed
Could anyone tell me if there any newer model gear cover that would fit on my stealth RC10 without any modification/ drill hole of the motor plates?
Thanks
Re: Gear cover RC10
Posted: Mon Mar 25, 2013 12:51 pm
by GoMachV
Are you looking for a hard plastic one, like an RPM? Because you can still find repro lexan ones as well as good used ones on eBay
Re: Gear cover RC10
Posted: Tue Mar 26, 2013 12:32 pm
by PKKC
Yes I am looking for the hard plastic one like rpm.
Re: Gear cover RC10
Posted: Tue Mar 26, 2013 1:21 pm
by transamman908
Re: Gear cover RC10
Posted: Tue Mar 26, 2013 1:47 pm
by jwscab
I haven't finished my investigation, but I think you can easily fit this part with some trimming and drilling new holes in it:
http://www3.towerhobbies.com/cgi-bin/WTI0001P?I=LXVVP0&P=8
I had this one, and an rc10 motor plate and eyeballed it a bit ago and it looked pretty compatible, just needed to determine the best placement of the holes and where to trim. it's been packed up for moving, so you'd have to investigate it yourself.