Page 1 of 1
Team Suzuki Goodness
Posted: Fri Apr 05, 2013 3:02 am
by aip47-2008
Did they also make Steering Knuckles for the "Works" & YZ-10 4WD'S ?
Re: Team Suzuki Goodness
Posted: Fri Apr 05, 2013 5:32 am
by Dual
Very nice Aaron. Have most of those parts on one of my upcoming projects.
Regarding the steering blocks, I don't think TS made them but I remember seeing natural finish aluminium versions on Brian Kinwalds and Mark Pavidis YZ10's circa 94-95.
Vin
Re: Team Suzuki Goodness
Posted: Fri Apr 05, 2013 6:48 am
by 59burst
i got one from Cross but never seen one from Suzuki. but the made body posts for '94 yz10
Re: Team Suzuki Goodness
Posted: Fri Apr 05, 2013 2:55 pm
by mamadoesntletme
nice! where did you get them?
Re: Team Suzuki Goodness
Posted: Fri Apr 05, 2013 7:09 pm
by bscotti
Hey Aaron, Is that center shaft the super duper rare version for a Hydra Drive?
Re: Team Suzuki Goodness
Posted: Fri Apr 05, 2013 9:32 pm
by proffesso
japanese says Hydra Center Shaft
so I guess it is, could be wrong, the text is small
Re: Team Suzuki Goodness
Posted: Fri Apr 05, 2013 9:41 pm
by Charlie don't surf
Awesome stuff!!!!!!!
Re: Team Suzuki Goodness
Posted: Sun Apr 07, 2013 12:59 pm
by aip47-2008
proffesso wrote:japanese says Hydra Center Shaft
so I guess it is, could be wrong, the text is small
Yep! Hydra Drive, and from my good friend Hyeong a few years back.
Re: Team Suzuki Goodness
Posted: Sun Apr 07, 2013 1:17 pm
by Coelacanth
aip47-2008 wrote:Did they also make Steering Knuckles for the "Works" & YZ-10 4WD'S ?
I don't know about Team Suzuki, but in case you're interested, I think Duratrax Cliff Climber knuckles would fit.
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXVFJ0&P=7
I have a feeling Yoke C-carriers for the front would work for one of my builds...any chance you could measure the space inside the top & bottom arms of the "C"? And I assume the pin holes are for 3mm suspension pins? Thanks!