RC10Talk - The Net's Largest Vintage R/C Community

Ok here is the question. What are target ranges for both gear ratio and rollout supposed to be for 1/12 pan cars on small carpet road track? I have looked at some charts and some calculators for the numbers, but what are the target numbers that you look for?

I am running 49mm rear tires with 76 spur and 50 pinon

thanks for all input in advance

It depends on the wind of the motor...

My blinky 17.5 car:
Geared 58/76
43mm rear tires
= 103mm roll-out

if your running mod it should be much less. I would reference some of the setup sheets on the AE site for a starting point.

I am running the novak club motor and esc 17.5 blinky ok I'll check that out

thanks GreenHell

i checked out some of the set-ups but they might as well been written in greek

What does the roll out number tell you?

thanks again

This document is a good read, pg 2 talks about rollout. It's written more for off-road, but it's still general enough to be applied to 1:1 on-road.
http://www.teamassociated.com/pdf/cars_and_trucks/shared/gear_ratios.pdf