Page 1 of 1
Outdrive help needed
Posted: Wed Nov 14, 2007 9:15 am
by shodog
What is the difference between outdrives for a B2 transmission and out drives for a first generation stealth like those found on the CE, RC10T and DS?
I have a set of MIP light drives I would like to use on an upcoming build.
Re: Outdrive help needed
Posted: Wed Nov 14, 2007 9:17 am
by templeofspeed
B2 is larger in diameter than the 2.25 and smaller than the 2.60. B2, B3 and T3 are the same.
Re: Outdrive help needed
Posted: Wed Nov 14, 2007 9:28 am
by mikedealer
i believe the b2 outdrives will work with the correct diff rings inside the original 2.25 but i could be wrong
Re: Outdrive help needed
Posted: Wed Nov 14, 2007 10:22 am
by shodog
The dives come with the diff rings, I guess I just need to see if the diff rings will line up with the balls and fit insed the main gear.
Re: Outdrive help needed
Posted: Wed Nov 14, 2007 11:00 am
by aconsola
templeofspeed wrote:B2 is larger in diameter than the 2.25 and smaller than the 2.60. B2, B3 and T3 are the same.
Shouldn't that be
T2,B3,t3, and GT?
Re: Outdrive help needed
Posted: Wed Nov 14, 2007 12:31 pm
by scr8p
b2, b3, and t3 are the same. 2.40
t2 and gt are the same. 2.60
Re: Outdrive help needed
Posted: Wed Nov 14, 2007 2:07 pm
by aconsola
I should have known better than to doubt temple, but for some reason thought that the GT was the same as the t2/3.
I had it halfway
